Injection molding companies are often more worried about the oil on the mold, and the production of a good engine is not a good mold, only a clean mold to produce a qualified engine. With the production plan, a variety of oil and dirt will accumulate in the mold around, not only damage the service life of the mold, but also extremely affected by the finished product qualification rate, in addition to oil, in addition to the gum is imperative. The cleaning of the mold can better serve the production, bright and oil-free finished workpiece without the support of the mold.
The traditional method of cleaning mold more or less some disadvantages, looking for a more suitable cleaning method can bring benefits for the enterprise, with the development of the laser cleaning industry, laser cleaning components have begun to start in the mold industry began to apply. The principle of laser cleaning is the use of high-frequency high-energy laser pulse irradiation of the surface of the workpiece, the coating layer can be instantly absorbed by the focused laser energy, so that the surface of the oil, rust spots or coatings undergoes instantaneous evaporation or stripping, high-speed and effective removal of the surface adhesions or surface coatings of the cleaning method, and the role of a very short time of the laser pulse in the appropriate parameters will not harm the metal substrate.
- No damage cleaning: non-abrasive, non-contact, no damage to the substrate, just remove surface contaminants;
- Low-cost cleaning: no consumables, running only a very small amount of power consumption;
